Foster–Seeley discriminator

Foster-Seeley (or "phase") discriminator schematic.

The Foster–Seeley discriminator^[1]^[2] is a common type of FM detector circuit, invented in 1936 by Dudley E. Foster^[3] and Stuart William Seeley. The Foster–Seeley discriminator was envisioned for automatic frequency control of receivers, but also found application in demodulating an FM signal.

The Foster–Seeley discriminator uses a tuned RF transformer to convert frequency changes into amplitude changes. A transformer, tuned to the carrier frequency, is connected to two rectifier diodes. The circuit resembles a full bridge rectifier.

The phase of the voltage at the secondary coil depends on whether the carrier is below or above the resonance, resulting in a positive or negative shift, respectively.

The circuit makes use of the $90^{\circ }$ phase difference occurring between the voltages in two coupled resonant circuits at the peak frequency.

Through the coupling capacitor $C_{k}$ , the primary voltage is applied to the center tap of the secondary, producing a sum and a difference $V_{center}\pm {\frac {V_{secondary}}{2}}$ on the top and the bottom terminals thereof, respectively.

Depending on the changing phase relationship of the input signal — $V_{primary}$ (and therefore $V_{center}$ ) with $V_{secondary}$ , the amplitude of the sum/difference at the upper or lower half, respectively, will be higher, which results in a change of the voltage across the output capacitors. The choke $L3$ , sometimes replaced by a resistor, provides a DC path through the rectifier diodes.

The demodulator's bandwidth depends on the Q factor of the resonant circuit; the phase response of the secondary (and therefore, the voltage response of the circuit) to $\Delta {f}$ is an S-curve.

Foster–Seeley discriminators are sensitive to both frequency and amplitude variations, unlike some detectors. Therefore a limiter amplifier stage must be used before the detector, to remove amplitude variations in the signal which would be detected as noise. The limiter acts as a class-A amplifier at lower amplitudes; at higher amplitudes it becomes a saturated amplifier which clips off the peaks and limits the amplitude.

Footnotes

^ Foster, D. E.; Seeley, S. W. (March 1937), "Automatic tuning, simplified circuits, and design practice", Proceedings of the Institute of Radio Engineers, 25 (3): 289–313, doi:10.1109/jrproc.1937.228940, part 1
^ 2121103, Seeley, Stuart W., "Frequency Variation Response Circuits", issued June 21, 1938
^ Dudley E. Foster: biographical information and photo: Proceedings of the Institute of Radio Engineers, vol. 29, page 571 (October 1941). Available on-line at: https://ieeexplore.ieee.org/stamp/stamp.jsp?arnumber=1694175

External links

schematic and operation

[1] Foster, D. E.; Seeley, S. W. (March 1937), "Automatic tuning, simplified circuits, and design practice", Proceedings of the Institute of Radio Engineers, 25 (3): 289–313, doi:10.1109/jrproc.1937.228940, part 1

[2] 2121103, Seeley, Stuart W., "Frequency Variation Response Circuits", issued June 21, 1938

[3] Dudley E. Foster: biographical information and photo: Proceedings of the Institute of Radio Engineers, vol. 29, page 571 (October 1941). Available on-line at: https://ieeexplore.ieee.org/stamp/stamp.jsp?arnumber=1694175

[1]

[2]

[3]

See also

Footnotes

External links